Now, I am getting a perfect first layer (better than S3D) and an nearly equivalent top layer. All theses changes has each time increased my print quality (initials one with the default BLV MGN profil were catastrophics). Enabled coasting and convert my 0.2mm in S3D to 0.26mm3 in Cura. Tried to mimic "wipe nozzle" + "only wipe on outer-most perimeers" S3D setting by using "outer wall wipe distance" of Cura. Set my retraction settings exactly the same. Set my speed a bit slower than in S3D because S3D seem to print slower than expected while Cura respect the entered speed. Set my layers height and width the same. There is a lot more parameters in Cura than in S3D, I feel like S3D is hiding a lot of stuffs behind the scene. So far, I have try to transpose all my S3D parameters to Cura, most of them look straight forward but I feel that they are not. My printer is based on a BLV MGN Cube and I print with a Volcano hotend + 0.6mm nozzle. I would like to switch from Simplif圓D to Cura but I struggling to find correct settings to get my print quality back.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |